Pulse counter with router
DB2-PULL-2NTC-BO
 |
Key features
|
The DB2-PULL-2NTC-BO is a battery powered ZigBee device, capable to count pulses emitted from flow rate meters (water, gas, electricity,...) and to measure the temperature from both the 2 on board NTC inputs. Pulse counters and temperature samples are sent at regular intervals to a gateway of Digitron products family.
Moreover, if temperature sensors are installed into an hydraulic circuit in the inlet and outlet pipes this device can send the difference between them.
|
Technical Specs
|
|
|
General characteristics
|
Chip Ember EM250
Compatible IEEE 802.15.4 Stack EmberZnet 3.5.x (ZigBee PRO) Modbus/RTU Device address settable via internal dip-switch Wall mounting with screws Cable gland: PG9 |
|
RF characteristics
|
Frequency: 2405 MHz ÷ 2480 MHz
Modulation: DSSS Nominal transmission power: 10mW (10 dBm) Reception sensitivity: -97 dBm External antenna gain: 5,5 dB Coverage outdoor/indoor: 200m/50m |
|
Supply
|
12/24Vcc/Vca; 100mA; 50/60Hz
|
|
NTC thermal resistor input
|
NTC type resistor
103AT type (R25 = 10 KOhm; Beta = 3435K) Measurement range: -50°C ÷ +110°C Measurement resolution: 0,1°C Measurement accuracy : ±0,5°C Measures are linearized at tenth of degree |
|
Digital inputs
|
Electronic type not insulated inputs for clean contact
Short circuit current 0,01mA. Use self-cleaning contact |
|
Connections
|
Pull out terminals (3,81 mm pitch)
|
|
Environment parameters
|
Operating temperature: -10 ÷ +60°C; <80% U.R. not condensing
Storage temperature: -20 ÷ +70°C; <80% U.R. not condensing Degree of protection: IP 55 |
|
Compliant with 2006/95/EEC,
89/336/EEC, 99/5/EEC directives
Reference Norms
|
ETSI EN 300 328: Radio Compatibility for digitals wide band transmissions
ETSI EN 301 489: Radio Compatibility EN 61000-6-2: Electromagnetic Compatibility - Emissions EN 61000-6-3: Electromagnetic Compatibility - Immunity EN 60950-1: Electric Safety |
UNI EN ISO 9001:2015
-
Organization with certified management system
-
Calibration Certificates Accredia