Sensor for temperature, humidity and light
DB2-RH-T-LX
![]() |
Key features
|
DB2-RH-T-LX is a battery powered device which perform temperature, humidity and light measurements at the same time and send them at regular intervals to a Gateway of the Digitron products family.
This device may be confi gured to manage alarm thresholds for exceeding maximum or minimum levels of measures.
It is also possible to adjust the sampling and data transmission rate to improve battery life.
The sensors are protected into a plastic material case such as Gore-Tex in order to let only air entering and no water.
Technical Specs
|
|
General characteristics
|
Chip Ember EM250
Compatible IEEE 802.15.4 Stack EmberZnet3.5.x (ZigBee PRO) Modbus/RTU Device address settable via internal dip-switch |
RF characteristics
|
Frequency: 2405 MHz ÷ 2480 MHz
Modulation: DSSS Nominal transmission power: 2mW (3 dBm) Reception sensitivity: -95 dBm Internal antenna gain: 0 dB Coverage outdoor/indoor: 100m/30m |
Supply
|
AA high energy density lithium battery 3,6V/2000mAh
Battery life: 3 years in case of 1 transmission per minute at 20°C |
Temperature/Humidity Sensor
|
Sensor used: Sensirion SMD SHT11 series
Temperature measurement range: from -40 to 120°C Reading accuracy inside measurement range: +/- 1,5°C max. Temperature measurements in tenth degrees Humidity measurement range: from 0 to 100% RH% Reading accuracy +/- 5 RH% max. |
Light/Sensor
|
Sensor used: Agilent ADPS-9002
Error : +/-5% in the range between 10 and 1000 Lux |
Environment parameters
|
Operating temperature: -10 ÷ +60°C; <80% U.R. not condensing
Storage temperature: -20 ÷ +70°C; <80% U.R. not condensing Degree of protection: IP 55 |
Compliant with 2006/95/EEC, 89/336/
EEC, 99/5/EEC directives
Reference Norms
|
ETSI EN 300 328: Radio Compatibility for digitals wide band transmissions
ETSI EN 301 489: Radio Compatibility EN 61000-6-2: Electromagnetic Compatibility - Emissions EN 61000-6-3: Electromagnetic Compatibility - Immunity EN 60950-1: Electric Safety |